Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-309
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
ISAPI-SLOT# Messages
Error Message IPV6-6-INTERFACE_EVENT: IP address [chars] [chars] on interface
[chars]
Explanation The IP address [chars] has been successfully [chars] on the interface [chars].
Recommended Action No action is required.
Error Message IPv6-6-IPV6_STATS_ERROR Format: Failed to get hardware statistics for
interface %s, reason %s
Explanation IPv6 could not get the requested statistics from the hardware.
Recommended Action No action is required.
Error Message IPV6-6-ROUTE_NOT_ACTIVE: The [chars] is not active
Explanation The specified route is successfully configured but currently is not active.
Recommended Action Check that the route is correct and the outgoing interface is operationally up.
Error Message IPV6-6-STARTING: IP configuration Manager started
Explanation The IP Configuration Manager service has successfully started.
Recommended Action No action is required.
Error Message IPv6-6-v6_REG_SEND_MSG Format: Suppress PIM6 Data Register for (%s,
%s) due to suppression-timer\n
Explanation Suppress PIM6 Data Register due to suppression-timer.
Parameters: Source address, Group address ...
Recommended Action No action is required.
ISAPI-SLOT# Messages
This section contains the ISAPI-SLOT# messages.
ISAPI-SLOT#-0
Error Message ISAPI-SLOT#-0-INVISTA_EMERG: [chars]
Explanation ISAPI-invista software messages.
Recommended Action No action is required.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English