Send document comments to nexus7k-feedback-doc@cisco.com
2-520
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
PORT-CHANNEL Messages
Error Message PORT-5-IF_TRUNK_UP: Interface [chars], vsan [chars] is up
Explanation The interface [chars] is trunking, VSAN [chars] is up.
Recommended Action No action is required.
Error Message PORT-5-IF_UP: Interface [chars] is up [chars]
Explanation The interface is up in the mode specified, if applicable.
Recommended Action No action is required.
Error Message PORT-5-MODULE_BRINGUP_NOT_ALLOWED: Not allowing module [dec] to come
up for reason: [chars] ([hex])
Explanation Module is not allowed to be operational due to the current system state.
Recommended Action Use command show module <x> recovery-steps and follow the steps
descRIBed.
Error Message PORT-5-MODULE_INDEX_RESTORE_ERROR: Error in restoring indices for
module [dec]: reason [chars] ([hex])
Explanation The restoration of the module index may fail due to overlap of indices.
Recommended Action No action is required.
Error Message PORT-5-MODULE_UNLIMITED_OSM_SEQ_FAILED: Enable/Disable of unlimited
oversubscription failed for module [dec]
Explanation Interfaces of the module may be in indeterminate state.
Recommended Action Reload the module.
PORT-CHANNEL Messages
This section contains the PORT-CHANNEL messages.
PORT-CHANNEL-1
Error Message PORT-CHANNEL-1-LC_CFG_FAILURE: configuring module [dec] failed
[[chars]]
Explanation Module configuration failed.
Recommended Action Module will be automatically reset.
To Next Page
Loading...
