Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-70
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
BOOTVAR Messages
Error Message BOOTVAR-5-AUTOCOPY_VERIFY_SEND_FAILED: Unable to ask standby to
verify file [chars], error = [hex]
Explanation When the image was copied to the standby supervisor module, the system failed to ask
the standby supervisor module to verify the integrity of the image.
Recommended Action Turn auto-copy off and back on.
Error Message BOOTVAR-5-AUTOSYNC_DONE: Image autosync done
Explanation The image synchronization was successful.
Recommended Action No action is required.
Error Message BOOTVAR-5-AUTOSYNC_REBOOT: Rebooting standby after successful
autosync
Explanation The image autosynchronization has been successful. The system is resetting the
standby supervisor to load the new image.
Recommended Action Check that the standby supervisor module reloads correctly.
Error Message BOOTVAR-5-AUTOSYNC_START: Starting image autosync. Please wait until
completion...
Explanation The standby supervisor module has requested the synchronizationof the current image.
Recommended Action No action is required.
Error Message BOOTVAR-5-IMAGE_NOTEXISTS: Warning: image [chars] doesn't exist on
sup[dec]
Explanation The input image name does not exist on the specified supervisor.
Recommended Action Check whether the input image name you entered exists and make sure that
you have the image on the flash before you reboot.
Error Message BOOTVAR-5-NEIGHBOR_UPDATE_AUTOCOPY: auto-copy supported by neighbor
supervisor, starting...
Explanation The information log reports that the standby supervisor module supports autocopy.
Autocopy is being started.
Recommended Action No action is required.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English