Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-221
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
FLOGI Messages
FICON-6
Error Message FICON-6-PDCM_CHANGE: VSAN [dec] port-address [dec] prohibit mask set
to [chars]
Explanation The FICON Prohibit Dynamic Connectivity Mask (PDCM) for this port has changed.
VSAN [dec], port address [dec] prohibit mask (PDCM) is now set to [chars].
Recommended Action No action is required.
Error Message FICON-6-PORT_SWAP: port number [dec] [dec] swapped
Explanation FICON port numbers swapped.
Recommended Action No action is required.
Error Message FICON-6-VSAN_DISABLED: FICON disabled on VSAN [dec]
Explanation FICON has been disabled on the given VSAN.
Recommended Action No action is required.
Error Message FICON-6-VSAN_ENABLED: FICON enabled on VSAN [dec]
Explanation FICON has been enabled on the given VSAN.
Recommended Action No action is required.
FLOGI Messages
This section contains the FLOGI messages.
FLOGI-1
Error Message FLOGI-1-MSG_FDISC_REJECT_TOO_MANY_LOGINS: [VSAN [dec], Interface
[chars]] FDISC rejected - this interface has reached the max num of N-Ports ([dec])
Explanation An FDISC was rejected because the F-Port has reached the maximum allowed number
of devices.
Recommended Action Check the configuration of the NPIV device connected to the port.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English