Send document comments to nexus7k-feedback-doc@cisco.com
2-497
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
PM Messages
Error Message PM-3-DUP_REG_ERR Format: %s is already registered with PM
Explanation A PM client tried to register more than once with PM.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message PM-3-ERROR Format: Failed to %s
Explanation A critical operation has failed in the PM process.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message PM-3-ETH_STUB_ERR Format: %s
Explanation A failure occurred in the Ethernet stub module.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message PM-3-HA_UPDATE Format: HA update failed (%d)
Explanation HA update failed.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message PM-3-IF_INDEX Format: Invalid interface index received from %d
Explanation An invalid interface index has been received.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message PM-3-INTERNAL_ERROR Format: %s
Explanation An internal error has occurred in the PM process.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message PM-3-IPC_ERR Format: %s
Explanation A failure occurred while communicating with another process.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
To Next Page
Loading...
Need help?
General
