Send document comments to nexus7k-feedback-doc@cisco.com
2-498
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
PM Messages
Error Message PM-3-MQ_SEND Format: Failed to send message %s (err: %s)
Explanation A message queue send operation failed.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message PM-3-MSG_TO_TLV Format: TLV Conversion failed (%d)
Explanation TLV conversion failed.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message PM-3-MTS_DROP Format: Error returned from mts_drop(), errno: %s
Explanation PM called an MTS API which returned an error.
Recommended Action No action is required.
Error Message PM-3-MTS_RECV Format: Error returned from mts_recv(), errno: %s
Explanation PM called an MTS API which returned an error.
Recommended Action No action is required.
Error Message PM-3-MTS_SEND Format: Failed to send message %s (err: %s)
Explanation PM called an MTS API which returned an error.
Recommended Action No action is required.
Error Message PM-3-NO_MBUF Format: Failed to allocate mbuf %s
Explanation The PM process has run out of network buffers.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message PM-3-NO_MEM Format: Failed to allocate private memory for %s
Explanation The PM process has run out of private memory.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
To Next Page
Loading...
