Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-124
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
DIAGMGR Messages
Error Message DIAGMGR-4-FIXED_INTRVL_CHANGED: The users are not allowed to change
monitoring interval of Test <[chars]>
Explanation The specified health monitoring test interval is not user-configurable and therefore
cannot be changed.
Recommended Action No action is required.The specific health monitoring interval is not user-
configurable by design so nothing can be done to change the interval.
DIAGMGR-5
Error Message DIAGMGR-5-BOOTUP_CONF: Diagnostic Bootup Level: <[chars]>
Explanation Current Diagnostic BootUp Level being configure or changed.
Recommended Action No action is required.
Error Message DIAGMGR-5-CALLOC_FAILURE: Memory allocation failure
Explanation Memory allocation in a call to malloc/calloc has failed.
Recommended Action No action is required.
Error Message DIAGMGR-5-CHANGE_ALWAYS_HM: Health Monitoring test <[chars]> in
Module <[dec]> is a must run and cannot be modified
Explanation The specified health monitoring test must be run and cannot be disabled.
Recommended Action No action is required.The specific health monitoring test cannot be disabled by
design. The system is working properly.
Error Message DIAGMGR-5-HM_START: Health monitoring test <[chars]> for Module
<[dec]>
Explanation Health Monitoring Test started.
Recommended Action No action is required.
Error Message DIAGMGR-5-HM_STOP: Disabling health monitoring test <[chars]> for
Module <[dec]>
Explanation Health Monitoring Test has been stopped It can be enabled through the diagnostic
monitor..... command.
Recommended Action No action is required.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English