EasyManuals Logo

Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Cisco AP775A - Nexus Converged Network Switch 5010
886 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #278 background imageLoading...
Page #278 background image
Send document comments to nexus7k-feedback-doc@cisco.com
2-240
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
HSRP_ENGINE Messages
HEAP-3
Error Message HEAP-3-HEAP_ERROR Format: %s
Explanation Heap routing library error.
Recommended Action No action is required.
HEAP-4
Error Message HEAP-4-HEAP_WARNING Format: %s
Explanation Heap malloc warning.
Recommended Action No action is required.
HSRP_ENGINE Messages
This section contains the HSRP_ENGINE messages.
HSRP_ENGINE-3
Error Message HSRP_ENGINE-3-NOSOCKET: Unable to open socket
Explanation The system was unable to initialize an IP connection for the Hot Standby protocol.
Recommended Action Make sure that there is at least one interface configured to run IP.
HSRP_ENGINE-4
Error Message HSRP_ENGINE-4-BADAUTH: Bad authentication from [chars], group [dec],
remote state [chars]
Explanation Two routers participating in HSRP disagree on the valid authentication string.
Recommended Action Use the HSRP authentication command to repair the HSRP authentication
discrepancy between the local system and the one whose IP address is reported.

Table of Contents

Other manuals for Cisco AP775A - Nexus Converged Network Switch 5010

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco AP775A - Nexus Converged Network Switch 5010 and is the answer not in the manual?

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General IconGeneral
BrandCisco
ModelAP775A - Nexus Converged Network Switch 5010
CategorySwitch
LanguageEnglish

Related product manuals