Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-823
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
XBAR Messages
XBAR-2
Error Message XBAR-2-ARB_INIT_FAIL: Arbiter Initialization failed return_code [hex]
([chars]).
Explanation The supervisor has experienced an arbiter setup failure .
Recommended Action No action is required.
Error Message XBAR-2-INCOMPATIBLE_CONFIG: [chars] [dec] [chars].
Explanation This module is not compatible with the current fabric mode. It will be powered down.
Recommended Action No action is required.
Error Message XBAR-2-XBAR_INSUFFICIENT_XBAR_BANDWIDTH: Module in slot [dec] has
insufficient xbar-bandwidth.
Explanation The system has detected insufficient xbar-bandwidth.
Recommended Action No action is required.
Error Message XBAR-2-XBAR_SUFFICIENT_XBAR_BANDWIDTH: Module in slot [dec] has
sufficient xbar-bandwidth.
Explanation The system has detected recovery from insufficient xbar-bandwidth.
Recommended Action No action is required.
XBAR-3
Error Message XBAR-3-MEM_FULL: Memory allocation failed.
Explanation The system has detected an error.
Recommended Action No action is required.
Error Message XBAR-3-MEM_FULL: Memory allocation failed. [chars] %i
Explanation The system has detected an error.
Recommended Action No action is required.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English