Send document comments to nexus7k-feedback-doc@cisco.com
2-577
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
RPM Messages
Error Message RPM-2-PPF_SES_VERIFY Format: PPF session verify failed in client %s
with an error 0x%08x(%s)
Explanation RPM has detected an error while pushing PBR policy changes during the verify stage
to PBR clients
Parameters: PPF-Client, Error code, Error message ...
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message RPM-2-PSS_SYNC_BUFFER Format: Crossed pss sync buffer size limit of
%d with payload size %d - in %s()
Explanation RPM tried to PSS synchronizationa message exceeding the maximum allowed size
Parameters: Pss synchronizationbuffer size, Message payload size, RPM Function ...
Recommended Action No action is required.
Error Message RPM-2-SMALLOC_FAILED Format: smalloc() failed for allocating %s in
%s()
Explanation RPM process is out of shared memory. This could be due to temporary increase in the
number of policies configured to a very high value
Parameters: Data, RPM Function ...
Recommended Action Use 'reload' command to reload the system. Be aware that this problem affects
all VDCs on the system.
Error Message RPM-2-SRV_INIT_API_FAIL Format: %s failed during initialization in
%s()
Explanation RPM called a server API during initialization which returned an error.
Parameters: Init. Function, RPM Function ...
Recommended Action Use 'reload' command to reload the system. Be aware that this problem affects
all VDCs on the system.
RPM-3
Error Message RPM-3-API_FAILED Format: %s - failed in %s()
Explanation RPM invoked an API which failed. This is an unexpected but manageableevent.
Parameters: Failed API, RPM Function ...
Recommended Action No action is required.
To Next Page
Loading...
Need help?
General
