Send document comments to nexus7k-feedback-doc@cisco.com
2-522
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
PORT-CHANNEL Messages
Error Message PORT-CHANNEL-3-GENERAL_ERROR: [chars]
Explanation General error.
Recommended Action No action is required.
Error Message PORT-CHANNEL-3-LC_CFG_TIMEOUT_ENTRY_PORT_ERR_DISABLE: Failed to send
LC config due to timeout, Port [chars] Err disabled
Explanation The system has failed to send a lc_config message.
Recommended Action No action is required.
Error Message PORT-CHANNEL-3-LC_CFG_UCAST_FAILED_PORT_ERR_DISABLE: Failed to send
LC config unicast msg, Port [chars] Err disabled
Explanation The system has failed to send a lc_config unicast message.
Recommended Action No action is required.
Error Message PORT-CHANNEL-3-LC_CFG_UCAST_SEND_FAILURE: Failed to send LC config
Unicast msg to slot [dec] node [hex] sap [dec]: [chars]. Resetting LineCard
Explanation The system has failed to send a lc_config unicast message.
Recommended Action No action is required.
Error Message PORT-CHANNEL-3-MSG_SEND_FAILURE: failed to send [chars] to sap [dec]:
[chars]
Explanation The system has failed to send a message.
Recommended Action No action is required.
Error Message PORT-CHANNEL-3-PORT_CHANNEL_NOT_FOUND: [chars] is not found
Explanation Cannot find port channel in its database, which indicates an inconsistency with an
external component.
Recommended Action No action is required.
Error Message PORT-CHANNEL-3-TIMEOUT: timed out after [dec] seconds [type [chars],
state [chars]]
Explanation Some operation timed out.
Recommended Action Run show port channel consistency to check all module connectivity and
consistency.