Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-811
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
VSAN Messages
VRRP_ENG-5
Error Message VRRP_ENG-5-INTERFACE_DOWN: Cannot start the VR[chars] [dec] since the
interface [chars] is down
Explanation The specified VR is enabled but cannot change state from init. The specified interface
is down or does not have a primary IP address configured.
Recommended Action No action is required.
Error Message VRRP_ENG-5-INTERFACE_STATE_CHANGE: Interface [chars] state changed to
[chars]
Explanation The interface specified has changed its state This could have triggered a VRRP status
change.
Recommended Action No action is required.
Error Message VRRP_ENG-5-STARTING: VRRP Engine service started
Explanation The service successfully started.
Recommended Action No action is required.
Error Message VRRP_ENG-5-VR_STATE_CHANGE: VR[chars] ID [dec] on interface [chars]
state changed to [chars]
Explanation The status of the specified virtual router has changed to [chars].
Recommended Action No action is required.
VRRP_ENG-6
Error Message VRRP_ENG-6-VSHA_RESULT: VR ID [dec] on interface [chars] state change
request result [chars]
Explanation The result of the request for status change on the virtual router (with VSHA extension)
specified is [chars].
Recommended Action No action is required.
VSAN Messages
This section contains the VSAN messages.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English