Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-129
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
DOT1X Messages
Error Message DOT1X-3-NOT_DOT1X_CAPABLE: interface [chars] because it is not a
physical Ethernet interface.
Explanation Dot1x Authentication can only be enabled on physical Ethernet interfaces.
Recommended Action Enable Dot1x Authentication on physical Ethernet interfaces only.
Error Message DOT1X-3-SM_INIT: Internal error while initializing state machine
[chars], state [chars]: [chars]
Explanation An attempt was made to initialize an invalid state machine.
Recommended Action Initialize dot1x state machine.
DOT1X-4
Error Message DOT1X-4-BADEVENT: Event [chars] is invalid for the current state
[chars]: [chars] [chars]
Explanation An attempt was made to post an event to a state machine that is invalid for the current
state.
Recommended Action Initialize dot1x state machine.
Error Message DOT1X-4-MAB_DISABLED: Interface [chars] is in Trunk mode, MAB is not
supported on this port
Explanation MAB is not supported on Trunk port.
Recommended Action To enable MAB make sure that port is not in trunk mode.
Error Message DOT1X-4-MAB_DISABLED: Interface [chars] is in Trunk mode, MAB will be
disabled on this port
Explanation MAB is not supported on Trunk port.
Recommended Action To enable MAB make sure that port is not in trunk mode.
Error Message DOT1X-4-MAB_DISABLED_ON_PCM: Interface [chars] is a member of
portchannel, MAB is not supported on this port
Explanation MAB is not supported on port channel member port.
Recommended Action To enable MAB make sure that port is not member of port channel.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English