Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-469
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
PIM6 Messages
PIM6-6
Error Message PIM6-6-IF_DEPEND Format: Removed interface (%s) has %s dependency
Explanation There is residual configuration on the deleted interface.
Parameters: Interface name, Dependent Config Command ...
Recommended Action No action is required.
Error Message PIM6-6-MAX_GRANGES Format: Max Granges allowed to be configured for
use shared tree config is %d
Explanation Exceeded the group range limit.
Recommended Action No action is required.
Error Message PIM6-6-MAX_RPS Format: Cannot store bidir-RP %s, a maximum of %d are
supported
Explanation Due to hardware limitations, there is a maximum number of Bidir-PIM6 RPs that can
be stored.
Recommended Action No action is required.
Error Message PIM6-6-MQFLUSHED Format: Flushing %lu messages from %s mq
Explanation Flushing old residual messages fom the message-queue.
Recommended Action No action is required.
Error Message PIM6-6-MQLOOP_UNKNOWN_MSG Format: Received unknown message %d/%d
Explanation PIM6 process received unknown Interprocess message, dropped.
Recommended Action No action is required.
Error Message PIM6-6-NEGATIVE_PREFIX Format: Group prefix %s/%d from RP %s has
negative-bit set, ignore group entry
Explanation The RP is advertising a group range to be in dense-mode. This implementation only
supports sparse-mode so the group entry will be igored.
Parameters: Type of malloc(size), Function Name ...
Recommended Action No action is required.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English