Send document comments to nexus7k-feedback-doc@cisco.com
2-468
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
PIM6 Messages
Error Message PIM6-3-U6RIB_CONTEXT Format: Couldn't get U6RIB VRF %s
Explanation PIM6 failed to obtain unicast routing VRF from URIB.
Parameters: Interface ...
Recommended Action Dump core, and and and then restart component.
Error Message PIM6-3-UDP_READ Format: Error reading UDP socket
Explanation UDP Socket Error.
Recommended Action Dump core, and and and then restart component.
Error Message PIM6-3-UDP_SENDTO Format: udp_sendto() on %s failed: %s
Explanation PIM6 failed to send over UDP socket.
Parameters: Message String Error String ...
Recommended Action No action is required.
Error Message PIM6-3-WRLOCK_ASSERT Format: %s:%d: Assert, write-lock not acquired
Explanation Caller Failed to get PIM6 Shared Memory write lock
Parameters: Function Name, Line ...
Recommended Action No action is required.
PIM6-5
Error Message PIM6-5-DR_CHANGE Format: DR change from %s to %s on interface %s
Explanation PIM Designated router changed on the interface.
Parameters: Old DR address, New DR address, Interface ...
Recommended Action No action is required.
Error Message PIM6-5-NBR_CHANGE Format: Neighbor %s %s on interface %s
Explanation PIM neighbor went up/down due to Hello-message seen/lost.
Parameters: Neighbor IPv6 address, Neighbor state, Interface ...
Recommended Action No action is required.
To Next Page
Loading...
