Cisco AP775A - Nexus Converged Network Switch 5010 - Isis-2

Send document comments to nexus7k-feedback-doc@cisco.com
2-316
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
ISIS Messages
Error Message ISIS-2-IIB_EXT Format: %s extension msg for %s (%d) - %s
Explanation An unexpected but recoverable event has occurred.
Recommended Action Use the 'restart' command to restart the feature and clear this problem.
Error Message ISIS-2-IM_DEL Format: Delete msg for %s (%d) iib %p - iib iod %d
mismatched
Explanation An unexpected but recoverable event has occurred.
Parameters: Interface Name, Interface Ordinal, Interface Memory, Interface Memory Ordinal Value
...
Recommended Action Use the 'restart' command to restart the feature and clear this problem.
Error Message ISIS-2-LSP_FREE_DELINK Format: L%d %s is not on free list
Explanation An unexpected but recoverable event has occurred.
Parameters: Level, LSP-ID ...
Recommended Action Use the 'restart' command to restart the feature and clear this problem.
Error Message ISIS-2-LSP_FREE_LINK Format: L%d %s is already on free list
Explanation An unexpected but recoverable event has occurred.
Parameters: Level, LSP-ID ...
Recommended Action Use the 'restart' command to restart the feature and clear this problem.
Error Message ISIS-2-MCAST_ADD Format: Failed to add L%d multicast address
Explanation Was unable to join to the appropriate multicast group on an interface.
Parameters: Level ...
Recommended Action Use the 'restart' command to restart the feature and clear this problem.
Error Message ISIS-2-MEM_ERR Format: Insufficient memory for %s
Explanation Memory is not available for adding SNP entries
Parameters: Reason ...
Recommended Action Use the 'restart' command to restart the feature and clear this problem.
Error Message ISIS-2-MQRCVD Format: %s thread - message queue receive failure <%d>
Explanation An unexpected but recoverable event has occurred.
Parameters: Thread Name, Error Number ...
Recommended Action Use the 'restart' command to restart the feature and clear this problem.