Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-365
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
LC_PORT_MGR-SLOT# Messages
Error Message LC_PORT_CHANNEL-SLOT#-3-LC_PORT_CHANNEL_IDXMAP_FAILURE: could not
lookup port index for interface [chars]
Explanation Could not look up port index.
Recommended Action No action is required.
LC_PORT_MGR-SLOT# Messages
This section contains the LC_PORT_MGR-SLOT# messages.
LC_PORT_MGR-SLOT#-2
Error Message LC_PORT_MGR-SLOT#-2-LC_MTS_ERROR: An MTS error has occurred in
([chars]) with the following conditions: opc=[dec] ssap=[hex] dsap=[hex]
syserr=[hex]
Explanation This is a software error in message communication between two applications.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
LC_RDL Messages
This section contains the LC_RDL messages.
LC_RDL-3
Error Message LC_RDL-3-SYSLOG_ALLOC_FAIL: : [chars]
Explanation RDL malloc failed : [chars].
Recommended Action No action is required.
Error Message LC_RDL-3-SYSLOG_CONTEXT_ERR: : [chars] [dec]
Explanation RDL context error: [chars] [dec].
Recommended Action No action is required.
Error Message LC_RDL-3-SYSLOG_ERR: : [chars]
Explanation RDL syslog errors : [chars].
Recommended Action No action is required.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English