EasyManuals Logo

Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Cisco AP775A - Nexus Converged Network Switch 5010
886 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #263 background imageLoading...
Page #263 background image
Send document comments to nexus7k-feedback-doc@cisco.com
2-225
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
FSPF Messages
FSPF-3
Error Message FSPF-3-BAD_FC2_PKT: Received bad FC2 packet on interface [chars] :
[chars]
Explanation FSPF received a bad FC2 packet on [chars] interface , error description is [chars].
Recommended Action FSPF daemon has received a bad FC frame. Provide the output of 'debug fc2
pkt '.
Error Message FSPF-3-CHECKSUM_FAIL: Checksum test failed for LSR domain [dec]
Explanation Periodic database checksum test failed for LSR for domain [dec].
Recommended Action This indicates that the internal database got corrupted because of some
memory corruption bug. Provide output of 'show fspf database '. May need to power cycle the
switch.
Error Message FSPF-3-FC2_PROC_ERR: Error in processing [chars] packet on interface
[chars], Error = [chars]
Explanation An error has occurred in processing a [chars] FC2 packet on [chars] interface. The
internal error code is [chars].
Recommended Action Turn on 'debug fspf error' to get more information. Make sure there is no
misconfiguration of FSPF parameters on the two ends of the interface. Provide output of 'show fspf
VSAN x' 'show fspf VSAN x interface' and 'debug fspf fc pkt ' for the specific interface.
Error Message FSPF-3-FLOOD_ERR: Error in flooding the local LSR , Error = [chars]
Explanation FSPF had an error in flooding the local LSR , error description is [chars].
Recommended Action Provide output of 'debug fspf flood' , 'debug fspf error'. If error is reported in
transmitting packet check if interface is up and turn on 'debug fc2 error'.
Error Message FSPF-3-HELLO_MISMATCH: Mismatch in [chars] in the Hello packet on
interface [chars]
Explanation There is a mismatch in the [chars] entry in the hello packet received on interface
[chars]. The packet will be dropped.
Recommended Action Check the configuration of hello or dead interval on the switches on the two
ends of the interface to see if there is a mismatch.

Table of Contents

Other manuals for Cisco AP775A - Nexus Converged Network Switch 5010

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco AP775A - Nexus Converged Network Switch 5010 and is the answer not in the manual?

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General IconGeneral
BrandCisco
ModelAP775A - Nexus Converged Network Switch 5010
CategorySwitch
LanguageEnglish

Related product manuals