Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-570
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
RIP Messages
Error Message RIP-3-SYSMGR_CLEANUP Format: Error returned from
sysmgrcb_conditional_srv_cleanup_status(): %d
Explanation RIP called a sysmgr API which returned an error.
Parameters: Status ...
Recommended Action No action is required.
Error Message RIP-3-UNK_MSG_MAJOR Format: %s thread - Unrecognized message major
type %d
Explanation An unknown message was received from another process
Parameters: Thread Name, Major Type ...
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message RIP-3-UNK_MSG_MINOR Format: %s thread - Unrecognized message minor
type %d
Explanation An unknown message (mior) was received from another process
Parameters: Thread Name, Minor Type ...
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
RIP-4
Error Message RIP-4-IF_DOWN_OVERLOAD Format: Interface %s brought down due to
overload condition for %s af
Explanation The interface has been brought down due to an overload condition
Parameters: Interface Name, Address Family ...
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message RIP-4-NO_MEM Format: Failed to allocate private memory
Explanation The RIP process has run out of private memory.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English