Send document comments to nexus7k-feedback-doc@cisco.com
2-765
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
URIB Messages
Error Message URIB-3-DEL_ERROR Format: Could not delete %s/%d from %s
Explanation A error was encountered. The system may run into more errors because of this problem.
Recommended Action Use the 'system switchover' command to switch over to the standby supervisor.
If no standby is present, or the standby is not ready, use the 'reload' command to reload the system.
The state of the standby can be checked using the 'show system redundancy ha status' command.
Error Message URIB-3-EPID_MIS_MATCH_ERROR Format: \%s\ epid (%u) does not match
known epid (%u)
Explanation The id a client provided does not match the id that URIB currently has stored for the
client. The client probably restarted ungracefully and URIB has the old id.
Parameters: Client, Expected epid, Received epid ...
Recommended Action Use the 'restart' command to restart the feature and clear this problem.
Error Message URIB-3-FILE_OPEN_ERROR Format: File open error: %s
Explanation This message is for internal debugging only.
Recommended Action No action is required.
Error Message URIB-3-FILE_WRITE_ERROR Format: File write error: %s
Explanation This message is for internal debugging only.
Recommended Action No action is required.
Error Message URIB-3-GENERAL_CRIB_ERROR Format: %s
Explanation CRIB not in use.
Recommended Action No action is required.
Error Message URIB-3-GENERAL_PTHREAD_ERROR Format: Thread %d: %s
Explanation The POSIX pthread library returned an error to URIB.
Parameters: Thread name, Thread operation ...
Recommended Action Use the 'system switchover' command to switch over to the standby supervisor.
If no standby is present, or the standby is not ready, use the 'reload' command to reload the system.
The state of the standby can be checked using the 'show system redundancy ha status' command.
To Next Page
Loading...
Need help?
General
