Send document comments to nexus7k-feedback-doc@cisco.com
2-826
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
XBAR Messages
Error Message XBAR-5-XBAR_INIT_FAILURE: XBAR [chars] initialization failed [chars]
%i
Explanation The supervisor has experienced a fabric initialization failure. The supervisor is going
to reboot. If you have two supervisor modules, a switchover will occur.
Recommended Action No action is required.
Error Message XBAR-5-XBAR_PORT_CHECK_SYNC_FAIL: Xbar [[dec].[dec]] reported failure
to check sync on port [dec] return_code [hex] ([chars]).
Explanation The supervisor has experienced an crossbar setup failure.
Recommended Action No action is required.
Error Message XBAR-5-XBAR_PORT_CONTINUE_SYNC_FAIL: Xbar [[dec].[dec]] reported
failure to continue sync on port [dec] return_code [hex] ([chars]).
Explanation The supervisor has experienced an crossbar setup failure.
Recommended Action No action is required.
Error Message XBAR-5-XBAR_PORT_DISABLE_FAIL: Xbar [[dec].[dec]] reported failure to
disable port [dec] return_code [hex] ([chars]).
Explanation The supervisor has experienced an crossbar setup failure.
Recommended Action No action is required.
Error Message XBAR-5-XBAR_PORT_ENABLE_FAIL: Xbar [[dec].[dec]] reported failure to
enable port [dec] return_code [hex] ([chars]).
Explanation The supervisor has experienced an crossbar setup failure.
Recommended Action No action is required.
Error Message XBAR-5-XBAR_PORT_FORCE_POE_DISABLE_FAIL: Xbar [[dec].[dec]] reported
failure to disable force poe mode on [dec] return_code [hex] ([chars]).
Explanation The supervisor has experienced an crossbar setup failure.
Recommended Action No action is required.
Error Message XBAR-5-XBAR_PORT_FORCE_POE_ENABLE_FAIL: Xbar [[dec].[dec]] reported
failure to enable force poe mode on [dec] return_code [hex] ([chars]).
Explanation The supervisor has experienced an crossbar setup failure.
Recommended Action No action is required.
To Next Page
Loading...
