Cisco AP775A - Nexus Converged Network Switch 5010

Send document comments to nexus7k-feedback-doc@cisco.com
2-61
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
BGP Messages
Error Message BGP-3-VRF_CTX Format: VRF %s, failed %s
Explanation An internal software error occurred.
Parameters: VRF Name, Operation ...
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message BGP-3-VRFAVL_OP Format: Failed vrf database operation: %s, vrf %s id
%lu
Explanation BGP was unable to perform a vrf database operation.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
BGP-4
Error Message BGP-4-APIMTSNOMSG Format: No MTS payload found on %s queue, opc %d
Explanation An unexpected but recoverable event has occurred.
Parameters: Queue name, MTS Opcode ...
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message BGP-4-ISSU_CHECK Format: Not ready for ISSU: Graceful Restart or hold
time check failed
Explanation No user action is required.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message BGP-4-ISSU_HOLDTIME Format: ISSU will be affected if hold time is less
than system switchover time (%d seconds)\n
Explanation No user action is required.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message BGP-4-MAXPEERS Format: Trying to configure more than %d neighbors
Explanation No user action is required.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.