Send document comments to nexus7k-feedback-doc@cisco.com
2-163
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
ETH_PORT_CHANNEL Messages
Error Message ETH_PORT_CHANNEL-5-LOAD_BALANCE_CONFIGURED: Port-channel load
balance algorithm has been configured to [chars]
Explanation The system has detected a load balance algorithm has been changed.
Recommended Action No action is required.
Error Message ETH_PORT_CHANNEL-5-MAX_CHANNEL_DISALLOWED: Module failed to come
online because port channel interface <port-channel number> greater than [dec] is
present
Explanation The port channel number configured on the switch is larger than 128.
Recommended Action Delete the set of port channel interface <port channel interface> which is
greater than 128.
Error Message ETH_PORT_CHANNEL-5-PORT_ADDED: [chars] added to [chars]
Explanation Ports are added to a port channel.
Recommended Action No action is required.
Error Message ETH_PORT_CHANNEL-5-PORT_DOWN: [chars]: [chars] is down
Explanation Port goes down in a port channel.
Recommended Action No action is required.
Error Message ETH_PORT_CHANNEL-5-PORT_HOT_STANDBY: [chars]: [chars] goes to
hot-standby
Explanation Port goes to hot-standby in a port channel.
Recommended Action No action is required.
Error Message ETH_PORT_CHANNEL-5-PORT_HOT_STANDBY_DOWN: [chars]: hot-standby port
[chars] is down
Explanation The system has detected a hot-standby member goes down.
Recommended Action No action is required.
Error Message ETH_PORT_CHANNEL-5-PORT_INDIVIDUAL_DOWN: individual port [chars] is
down
Explanation The system has detected a member operating in individual mode goes down.
Recommended Action No action is required.