Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-105
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
DEVICE_TEST Messages
Error Message DEVICE_TEST-2-TWOWIRE_STW_FAIL: Module [dec] has failed test [chars]
[dec] times on Status Bus on slot [dec] due to error [chars]
Explanation The online diagnostic Status bus test has failed.
Recommended Action No action is required.
Error Message DEVICE_TEST-2-USB_FAIL: Module [dec] has failed test [chars] [dec]
times on device USB due to error [chars]
Explanation The online diagnostic USB test has failed.
Recommended Action No action is required.
DEVICE_TEST-3
Error Message DEVICE_TEST-3-STANDBY_TEST_GET_DIAG_VQI_FAIL: Standby test get diag
vqi failed due to error [hex]
Explanation The Device Test StandbyLoopback Test get vqi has failed.
Recommended Action No action is required.
Error Message DEVICE_TEST-3-STANDBY_TEST_GET_SPINE_FAIL: Standby test get spines
failed due to error [hex]
Explanation The Device Test StandbyFabricLoopback Test get spine has failed.
Recommended Action No action is required.
Error Message DEVICE_TEST-3-STANDBY_TEST_INIT_FAIL: Init for standby test failed
due to error [hex]
Explanation The Device Test StandbyFabricLoopback Test initialization process has failed.
Recommended Action No action is required.
Error Message DEVICE_TEST-3-STANDBY_TEST_MTS_FAIL: Mts Init for standby test failed
due to error [hex]
Explanation The Device Test StandbyFabricLoopback Test mts initialization has failed.
Recommended Action No action is required.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English