Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-192
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
FCDOMAIN Messages
FCDOMAIN-2
Error Message FCDOMAIN-2-DOMS_CONFLICT: Conflict detected: ([dec]) domain ID [dec]
WWN [chars]
Explanation Conflict detected ([dec]) domain ID [dec] with WWN [chars].
Recommended Action Check which switches have the same WWN and change either one; then
change either one's domain ID.
Error Message FCDOMAIN-2-EPORT_ISOLATED: Isolation of interface [chars] (reason:
[chars])
Explanation Fcdomain has isolated interface [chars] (reason: [chars].) Perform a show interface.
Based on the reason specified, you might have to ensure domains are adequate and unique in the
VSAN and perform a disruptive restart [fcdomain restart disruptive VSAN <VSAN-id>] or to
reinitialize the port.
Recommended Action No action is required.
Error Message FCDOMAIN-2-FC2_INITIALIZATION_FAILED: FC initialization sequence
failed
Explanation The fcdomain has not been able to complete the initialization sequence with the Fibre
Channel subsystem. fcdomain depends on resources not available at the moment: the switch might
be short in memory or some other component might be unable to provide the necessary information
to fcdomain.
Recommended Action No action is required.
Error Message FCDOMAIN-2-FC2_SET_SOCKOPT_DM_SOCK_FAILED: set sockopt to FC2 Service
failed
Explanation Fcdomain has not been able to setsockopt to the FC2 module.
Recommended Action No action is required.
Error Message FCDOMAIN-2-FC2BIND_FAILED: Bind to FC2 Service failed
Explanation Fcdomain has not been able to contact the FC2 module.
Recommended Action No action is required.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English