Send document comments to nexus7k-feedback-doc@cisco.com
2-248
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
ICMPV6 Messages
Error Message ICMPv6-3-TLV_TO_STRUCT Format: TLV to Struct Conversion failed (%d)
Explanation TLV to Struct conversion failed.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message ICMPv6-3-TXLIST_CREATE Format: Couldn't create txlist for %s
Explanation ICMPV6 has failed to create a txlist resource.
Parameters: Data type ...
Recommended Action Dump core, and then restart component.
Error Message ICMPv6-3-VRF_CREATE Format: ICMPv6 VRF creation failed for vrf %s
Explanation ICMPv6 process could not create the VRF context.
Parameters: VRF name ...
Recommended Action Dump core, then reload the stack.
ICMPV6-6
Error Message ICMPv6-6-RESERVE_LIMIT_WARNING Format: Exceeded 80% of the
reserve-limit for interface %s
Explanation Exceeded 80% of the reserve-limit for the interface
Parameters: Interface ...
Recommended Action No action is required.
Error Message ICMPv6-6-STATE_LIMIT_WARNING Format: Exceeded 80% of the state-limit
for interface %s
Explanation Exceeded 80% of the state-limit for the interface
Parameters: Interface ...
Recommended Action No action is required.
Error Message ICMPv6-6-UNKNOWN_OPC Format: Received unknown mts opcode %d
Explanation ICMPv6 process received unknown Interprocess message, dropped.
Recommended Action No action is required.
To Next Page
Loading...
