Send document comments to nexus7k-feedback-doc@cisco.com
2-335
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
IVR Messages
Error Message IVR-3-DOMAIN_UNAVAILABLE: Device with port WWN [chars] and FCID
[chars] may not be able to participate in Inter-VSAN zone since domain [dec] is
already assigned in VSAN [dec]
Explanation Device with port WWN [chars] and FCID [dec] may not be able to participate in
Inter-VSAN zone since domain [dec] is already assigned in VSAN [dec].
Recommended Action No action is required.
Error Message IVR-3-FC2_ERROR: FC2 API [chars] failed with error [hex] for [chars]
Explanation IVR invoked FC2 API for [chars] socket and received the error code. [chars] describes
the API and 0x[hex] specifies the error.
Recommended Action No action is required.
Error Message IVR-3-FCID_NAT_MODE_CANNOT_CHANGE: IVR NAT mode cannot be changed.
Might cause the fabric NAT mode inconsistency
Explanation Could be caused by active zone set, pending activation /deactivation or non-empty
device list.
Recommended Action No action is required.
Error Message IVR-3-FCID_REWRITE_REQUEST_TO_ACL_FAILED: fcid rewrite [chars]
request vsan [dec] did [chars] sid [chars] failed:[chars]([hex]).
Explanation This happens when either after IVR retried the request a few times or ACL experienced
error while processing the request.
Recommended Action No action is required.
Error Message IVR-3-INTERNAL_ERROR: Internal error: [chars]
Explanation IVR process encountered a generalerror thatdoes not fall in any of the categories.
[chars] describes the error and its context.
Recommended Action No action is required.
Error Message IVR-3-INVALID_ZONE_MEMBER_PROP_INTEROP_MODE_2_3: unsupported
member/zone properties in interop mode 2 or 3 [chars]
Explanation Inter-VSAN member properties incompatible with interop mode VSAN.
Recommended Action No action is required.
To Next Page
Loading...
Need help?
General
