Send document comments to nexus7k-feedback-doc@cisco.com
2-380
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
M6RIB Messages
Error Message M6RIB-3-NO_GROUP Format: Unable to create group entry for %s
Explanation M6RIB process unable to create the route entry in its route-table.
Parameters: Group ...
Recommended Action No action is required.
Error Message M6RIB-3-NO_MPIB Format: Unable to get mpib index in
m6rib_register_internal()
Explanation M6RIB process cannot register the protocol as it has run out of PIB indices.
Recommended Action Dump core, then reload the stack.
Error Message M6RIB-3-NO_SET_PRIORITY Format: Failed to set policy or priority
Explanation M6RIB process could not set itself process priority, exiting.
Recommended Action No action is required.
Error Message M6RIB-3-NO_SOURCE Format: Unable to create source entry for %s
Explanation M6RIB process unable to create the route entry in its route-table.
Parameters: Source ...
Recommended Action No action is required.
Error Message M6RIB-3-NO_TIMER Format: Could not create stale timer for \%s\
Explanation M6RIB process cannot stale the routes for this procotol.
Parameters: PIB Name ...
Recommended Action Dump core, then reload the stack.
Error Message M6RIB-3-OPCODE_REGISTER Format: %s opcode: 0x%x ErrorString: %s
Explanation Opcdoe registration failed
Parameters: Message Return Code Error String ...
Recommended Action No action is required.
Error Message M6RIB-3-PSS Format: Error returned from %s, errno: 0x%08x (%s) in %s()
Explanation M6RIB called a PSS API which returned an error. The error reported should be
examined for the cause.
Parameters: Failed API, Error Code, Error Description, M6RIB Function ...
Recommended Action ERRMSG.