Send document comments to nexus7k-feedback-doc@cisco.com
2-387
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
MODULE Messages
MODULE-2
Error Message MODULE-2-LCM_PRE_UPGRADE_GENERAL_FAIL: Pre upgrade message fails seq
[dec]
Explanation Pre upgrade message failed.
Recommended Action No action is required.
Error Message MODULE-2-LCM_UPGRADE_DONE_GENERAL_FAIL: Upgrade done message fails
SAP [chars]
Explanation Upgrade ready message failed.
Recommended Action No action is required.
Error Message MODULE-2-LCM_UPGRADE_OVER_FAIL: Upgrade over message returned [dec]
[hex] for SAP [dec]
Explanation Upgrade done message failed.
Recommended Action No action is required.
Error Message MODULE-2-LCM_UPGRADE_READY_FAIL: Upgrade ready message returned [dec]
[hex] for SAP [dec]
Explanation Upgrade ready message failed.
Recommended Action No action is required.
Error Message MODULE-2-LCM_UPGRADE_READY_GENERAL_FAIL: Upgrade ready message fails
SAP [chars]
Explanation Upgrade ready message failed.
Recommended Action No action is required.
Error Message MODULE-2-MOD_DIAG_FAIL: Module [dec] (serial: [chars]) reported
failure [chars] due to [chars] in device [dec] (device error [hex])
Explanation The module in slot [decimal digit] reported a failure in the runtime diagnostic. Module
manager is going to power cycle the module.
Recommended Action Collect information about the module by issuing the command 'show module
internal all module [decimal digit]'.
To Next Page
Loading...
