Send document comments to nexus7k-feedback-doc@cisco.com
2-424
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
NPV Messages
Error Message NPV-6-NPIV_DISABLED: [chars]
Explanation NPIV feature has been disabled.
Recommended Action No action is required.
Error Message NPV-6-NPIV_ENABLED: [chars]
Explanation NPIV feature has been enabled.
Recommended Action No action is required.
Error Message NPV-6-NPV_ENABLE_DISABLE_IN_PROGRESS: [chars]
Explanation NPV feature enable/disable is in progress. This sylog is printed at the beginning of
various significannot phases.
Recommended Action No action is required.
Error Message NPV-6-NPV_LOAD_BALANCE_TIMER_START: (Re)starting automatic load
balancing timer for [dec] seconds
Explanation Timer started for upon external interface up or server interface down. When the timer
goes off some of the server interfaces may be reinitialized to evenly distRIBute the server interfaces
among the eligible external interfaces.
Recommended Action No action is required.
Error Message NPV-6-SERVER_PROXY_LOGO_SENT: [chars]
Explanation NPV process sent a LOGO frame to the core switch as the server interface went down.
Recommended Action No action is required.
NPV-7
Error Message NPV-7-CFS_REQ_RCVD: [chars]
Explanation CFS request is received. The WWN of the switch originated this request and the
rr-token of the request are provided in the syslog message.
Recommended Action No action is required.
To Next Page
Loading...
