Send document comments to nexus7k-feedback-doc@cisco.com
2-445
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
PIM Messages
Error Message PIM-3-CREATE_ROUTE Format: Couldn't create PIM route for %s in %s
Explanation PIM failed to update the local route-table entry.
Parameters: Addresses, Function Name ...
Recommended Action No action is required.
Error Message PIM-3-CV_INIT Format: Couldn't init cond var %s
Explanation PIM process failed to initialize a conditional-variable resource.
Parameters: Thread Name ...
Recommended Action Dump core, and and and then restart component.
Error Message PIM-3-DEL_IF Format: Couldn't delete interface %s from PIM route %s
in %s ; Explanation: PIM failed to delete the outgoing interface from route-table
entry.
Explanation The system has detected an error.
Parameters: Interface, Addresses, Function Name ...
Recommended Action No action is required.
Error Message PIM-3-DEL_ROUTE Format: Couldn't delete PIM route %s in %s
Explanation PIM failed to delete the local route-table entry.
Parameters: Addresses, Function Name ...
Recommended Action No action is required.
Error Message PIM-3-FREE_ROUTE Format: Couldn't free PIM route %s in %s
Explanation PIM failed to delete the route-table entry.
Parameters: Addresses, Function Name ...
Recommended Action No action is required.
Error Message PIM-3-HEARTBEAT_TIMER Format: Unable to create heartbeat timer in %s
Explanation The system is unable to create heartbeat timer
Parameters: Function Name ...
Recommended Action Dump core, and and and then restart component.
Error Message PIM-3-IGMP_DOWN Format: Couldn't enable PIM on %s, IGMP is not up
Explanation PIM is not enabled on the interface, as it requires IGMP to be up.
Parameters: Interface ...
Recommended Action No action is required.
To Next Page
Loading...
Need help?
General
