Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-18
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
ACLTCAM Messages
Error Message ACLTCAM-2-RECONS_FAILED: Reconstruction of TCAM contents failed
during upgrade - [hex].
Explanation During nondisruptive upgrade, the ACLTCAM contents are not properly reconstructed.
[hex] is the error.
Recommended Action No action is required.
ACLTCAM-3
Error Message ACLTCAM-3-REGISTER_FAILED: Could not register to MTS opcode [chars]
- error [hex].
Explanation ACLTCAM process could not register to the notifications mentioned by [chars]. [hex]
is the error.
Recommended Action No action is required.
ACLTCAM-4
Error Message ACLTCAM-4-ACL_TCAM_BELOW_THRESHOLD: [chars] TCAM usage ([dec]/[dec])
fell below [dec]% fwd-eng: [dec], [chars]
Explanation [chars] TCAM usage [dec]/[dec] fell below [dec] percent on fwd-engine [dec], [chars].
Recommended Action No action is required.
Error Message ACLTCAM-4-ACL_TCAM_BEYOND_THRESHOLD: [chars] TCAM usage ([dec]/[dec])
exceeded [dec]% fwd-eng: [dec], [chars]
Explanation [chars] TCAM usage [dec]/[dec] exceeded [dec] percent on fwd-engine [dec], [chars].
Recommended Action No action is required.
Error Message ACLTCAM-4-ACL_TCAM_FLOW_COUNTER_INVALIDATED: Flow counter for flow:
vsan: [dec], sid: [hex], did: [hex] with statistics: frames = %llu & bytes = %llu
was invalidated due to: [chars]
Explanation ACLTCAM process invalidated the flow counter for flow VSAN [dec] SID [hex] DID
[hex] with collected stats of [dec] frames and [dev] bytes was invalidated because of reason
[[chars]].
Recommended Action No action is required.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English