Send document comments to nexus7k-feedback-doc@cisco.com
2-678
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
SYSMGR Messages
Error Message SYSMGR-2-GSYNC_FAILED_ACTIVE: global sync failed for UUID [hex]
Explanation Gsynchronizationctrl on active has failed.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message SYSMGR-2-GSYNC_FAILED_STDBY: standby fails due to gsync failure on
[chars]
Explanation Standby fails/resets due to gsynchronization failure.
Recommended Action Use the command 'reload module <mod>' to reset the standby supervisor if you
want to try again.
Error Message SYSMGR-2-GSYNC_GET_TIMEOUT: Request for global sync for UUID [hex]
not completed in specified time.
Explanation Service failed to complete global synchronizationin specified time. The standby will no
longer act as a HA standby.
Recommended Action If the problem persists, please contact customer support.
Error Message SYSMGR-2-GSYNC_READY_SRVFAILED: Service [chars] on standby supervisor
failed to restore its snapshot (error-id [hex]).
Explanation The initial synchronization of service [chars] has failed.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message SYSMGR-2-GSYNC_SNAPSHOT_SRVFAILED: Service [chars] on active
supervisor failed to store its snapshot (error-id [hex]).
Explanation The initial synchronization of service [chars] has failed.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message SYSMGR-2-HANDSHAKE_FAILED: Handshake with service [chars] in vdc
[dec] failed since send failed: [chars] (error-id [hex]).
Explanation Handshake with a service failed since system manager could not send handshake
response to it.
Recommended Action No action is required.
To Next Page
Loading...
