Send document comments to nexus7k-feedback-doc@cisco.com
2-34
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
ARP Messages
Error Message ARP-3-MBUF_ERR Format: Failed to get the remainder of packet, expected
%d, got %d bytes
Explanation An unexpected but recoverable error has occurred.
Recommended Action No action is required.
Error Message ARP-3-MTS_DROP Format: MTS drop failed on %s queue: %s
Explanation An unexpected but recoverable error has occurred.
Recommended Action No action is required.
Error Message ARP-3-NO_MBUF Format: Failed to allocate buffer for %s
Explanation The system may have run out of packet memory buffers.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message ARP-3-NO_MEM Format: Malloc failed for %s %s
Explanation The system may be low on memory.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message ARP-3-PKT_ENCAP Format: Failed to encapsulate packet
Explanation An unexpected but recoverable error has occurred.
Recommended Action No action is required.
Error Message ARP-3-PKT_OUT Format: Failed to send packet to PM
Explanation PM's message queue may be temporarily full.
Recommended Action No action is required.
Error Message ARP-3-REQ_ADD Format: Failed to add adjacency while sending request
for %s on %s, request from pid: %d
Explanation An unexpected but recoverable error has occurred.
Recommended Action No action is required.
To Next Page
Loading...
