Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-689
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
SYSMGR Messages
Error Message SYSMGR-2-PARSEERR_TOOMANYDEPENDS: [chars]: too many dependencies
([dec]) for service [chars].
Explanation The system image contains an inconsistent list of services. The initialization of the
system cannot proceed further.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message SYSMGR-2-PARSEERR_TOOMANYDEPENDS_MULTIPLE_INST: [chars]: too many
multiple instance dependencies ([dec]) for service [chars].
Explanation The system image contains an inconsistent list of services. The initialization of the
system cannot proceed further.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message SYSMGR-2-PARSEERR_UGRPDUPLICATEDNAME: [chars]: upgrade group name
[chars] already used in [chars].
Explanation The system image contains an inconsistent list of services. The initialization of the
system cannot proceed further.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message SYSMGR-2-PARSEERR_UGRPNAMEREDEFINED: [chars]: the upgrade group is
already called [chars].
Explanation The system image contains an inconsistent list of services. The initialization of the
system cannot proceed further.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message SYSMGR-2-PARTIAL_CFGWRITE_ABORTED: Partial configuration copy
aborted.
Explanation A partial configuration copy has failed.
Recommended Action Verify the other syslog messages printed correct the problem, and try again. If
problem persists, please run the command 'copy running-config startup-config' and try again.
Error Message SYSMGR-2-PLUGIN_BOOTUP_FAILURE: The bootup of the supervisor has
failed due to plugin load: [chars] (error-id [hex])
Explanation The bootup of the supervisor has failed due to plugin load.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English