Send document comments to nexus7k-feedback-doc@cisco.com
2-723
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
SYSTEMHEALTH Messages
Error Message SYSTEMHEALTH-4-OHMS_MOD_SNAKE_TEST_ERRORS: Snake Loopback test cannot
proceed due to internal errors for module [dec].
Explanation Snake test internal errors.
Recommended Action No action is required.
Error Message SYSTEMHEALTH-4-OHMS_NVRAM_ERRORS: Too many errors on module [dec]
while running the Nvram test.
Explanation Nvram test has had too many errors while running.
Recommended Action No action is required.
Error Message SYSTEMHEALTH-4-OHMS_SERDES_FAILED: SERDES loopback test on interface
fc[dec]/[dec] failed.
Explanation The system Health SERDES Test Failure.
Recommended Action No action is required.
Error Message SYSTEMHEALTH-4-OHMS_SUP_BOOTFLASH_ERRORS: Bootflash test has
encountered an error on module [dec] Reason ([dec]).
Explanation Compact flash test errors on supervisor.
Recommended Action No action is required.
Error Message SYSTEMHEALTH-4-OHMS_SUP_BOOTFLASH_ERRORS: Bootflash test has
encountered an error on module [dec] Reason:([chars]).
Explanation Compact flash test errors on supervisor.
Recommended Action No action is required.
Error Message SYSTEMHEALTH-4-OHMS_SUP_CF_CRC_INTERN_ERRORS: Compact flash firmware
CRC checksum procedure cannot proceed due to internal errors on module [dec].
Explanation Compact flash firmware CRC checksum procedure ended up in errors.
Recommended Action Try restarting the cf-crc-check using system health clear-errors module <x>
cf-crc-check. If the condition still persists, schedule a downtime and replace the compact flash on
the affected module.