Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-47
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
BGP Messages
BGP-3
Error Message BGP-3-ACLTESTADD Format: Failed to add %s peer policy test
Explanation An internal software error occurred.
Parameters: ACL type ...
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message BGP-3-AGGADD Format: [%s] Couldn't add aggregate for %s/%d
Explanation BGP was unable to store an aggregate in an internal datastructure. The BGP process
may have run out of memory.
Recommended Action If BGP ran out of memory, add memory to the router or change the network
configuration to decrease memory requirements. Clear any BGP peers that may have been shut down
automatically. If BGP has available memory, restart BGP.
Error Message BGP-3-AGGDEL Format: [%s] Couldn't delete aggregate for %s/%d
Explanation An unexpected but recoverable event has occurred.
Parameters: Address-family, Prefix/masklength ...
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message BGP-3-ALLOCFAIL Format: %s malloc (%ld) failed for: %s
Explanation The system may be low on memory.
Parameters: Alloc Type, Size, Error ...
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message BGP-3-API_UNEXP_RESP Format: Received unexpected message from SAP %d,
opcode %d, address %s, ignore it
Explanation An unexpected but recoverable event has occurred.
Parameters: MTS SAP, MTS Opcode, IP Address ...
Recommended Action No action is required.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English