Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-845
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
ZONE Messages
ZONE-5
Error Message ZONE-5-ZS_EXPORT_IMPORT_COMPLETE: [chars] operation completed
Explanation [chars] (Export/Import) operation completed.
Recommended Action No action is required.
Error Message ZONE-5-ZS_POLICY_CHANGE: Default zoning policy changed to [chars]
Explanation Default zoning policy changed to (permit/deny).
Recommended Action No action is required.
Error Message ZONE-5-ZS_ZONE_SET_ACTIVATED: Zoneset [chars] activated
Explanation Zoneset [chars] activated.
Recommended Action No action is required.
Error Message ZONE-5-ZS_ZONE_SET_DEACTIVATED: Zoneset deactivated
Explanation Zoneset deactivated.
Recommended Action No action is required.
ZONE-6
Error Message ZONE-6-LZ_BECAME_ACTIVE: LUN/Read-only zoning process became ACTIVE
from standby mode
Explanation The LUN/Read-only zoning process on the standby supervisor became active.
Recommended Action No action is required.
Error Message ZONE-6-LZ_BECAME_STDBY: LUN/Read-only zoning process became STANDBY
from active mode
Explanation The LUN/Read-only zoning process became standby from active mode.
Recommended Action No action is required.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English