64 Command Modes
dot1x system-auth-control Enables 802.1x globally.
enable password Sets a local password to control access to normal and privilege levels.
end Ends the current configuration session and returns to the previous
command mode.
gvrp enable (global) Enables GVRP globally.
hostname Specifies or modifies the device host name.
interface ethernet Enters the Interface Configuration mode to configure an Ethernet type
interface.
show interfaces port-channel Enters the Interface Configuration mode of a specific port-channel.
interface ethernet Enters the Interface Configuration mode to configure multiple
ethernet type interfaces.
interface range port-channel Enters the Interface Configuration mode to configure multiple port-
channels.
interface range vlan Enters the Interface Configuration mode to configure multiple VLANs.
interface tunnel Enters tunnel interface configuration mode.
interface vlan Enters the Interface Configuration (VLAN) mode.
ip default-gateway Defines a default gateway.
ip domain-lookup Enables the IP Domain Naming System (DNS)-based host name-to-
address translation.
ip domain-name Defines a default domain name, that the software uses to complete
unqualified host names.
ip host Defines static host name-to-address mapping in the host cache.
ip http authentication Specifies authentication methods for http.
ip http port Specifies the TCP port for use by a web browser to configure the device.
ip https server
Enables the device to be configured from a browser
.
ip https authentication Specifies authentication methods for https
ip https certificate Configures the active certificate for HTTPS. Use the no form of this
command to return to default.
ip https server
Enables the device to be configured from a secured browser
.
ip https port Configures a TCP port for use by a secure web browser to configure the
device.
ip igmp snooping (Global) Enables Internet Group Management Protocol (IGMP) snooping
ip name-server Sets the available name servers.
ip ssh port Specifies the port to be used by the SSH server.
ip ssh pubkey-auth Enables public key authentication for incoming SSH sessions.
5400_CLI.book Page 64 Wednesday, December 17, 2008 4:33 PM