Command Modes 65
ip ssh server Enables the device to be configured from a SSH server.
ipv6 default-gateway Defines an IPv6 default gateway.
ipv6 host Defines a static host name-to-address mapping in the host name cache.
ipv6 icmp error-interval Configures the rate limit interval and bucket size parameters for IPv6
ICMP error messages.
ipv6 neighbor Configures a static entry in the IPv6 neighbor discovery cache.
lacp system-priority Configures the system LACP priority.
line Identifies a specific line for configuration and enters the Line
Configuration command mode.
logging Logs messages to a syslog server.
logging buffered Limits syslog messages displayed from an internal buffer based on
severity.
logging buffered size Changes the number of syslog messages stored in the internal buffer.
logging console Limits messages logged to the console based on severity.
The following example clears
messages from the internal
syslog message logging buffer.
Limits syslog messages sent to the logging file based on severity.
logging on Controls error messages logging.
login authentication Specifies the login authentication method list for a remote telnet or
console.
management access-class Defines which management Access-List is used.
management access-list Defines a management Access-List, and enters the Access-List for
configuration.
port jumbo-frame Enables jumbo frames for the device.
port storm-control include-
multicast
Enables the device to count Multicast packets.
priority-queue out num-of-
queues
Enables the egress queues to be expedite queues.
qos Enables quality of service (QoS) on the device and enters QoS basic or
advance mode.
qos map dscp-queue Modifies the DSCP to CoS map.
qos trust (Global) Configure the system to "trust" state.
radius-server deadtime Improves RADIUS response times when servers are unavailable.
radius-server host Specifies a RADIUS server host.
radius-server key Sets the authentication and encryption key for all RADIUS
communications between the router and the RADIUS daemon.
5400_CLI.book Page 65 Wednesday, December 17, 2008 4:33 PM
To Next Page
Loading...
