iView - Controller View
9-6 Manual # 42-02-7223
• Passenger: The car is operating in normal passenger mode, responding to dispatching and
parking instructions and to hall and car call demands. Car and door operation are deter-
mined by settings on the Configuration > Car Operation > Passenger tab. Please refer to
“Car Operation - Passenger Tab” on page 9-41.
• Sabbath Operation: The elevator is operating in Sabbath mode initiated by a software
command, switched input or timer. Sabbath mode allows the elevator to operate, serving
the building without requiring buttons to be pressed for hall calls or car calls. Car behavior
is determined by parameters located on the Configuration > Car Operation > Sabbath
operation tab. Please refer to “Car Operation - Sabbath Tab” on page 9-85.
• Shuttle service: The elevator is operating in Shuttle service mode initiated by a key-switch/
input, software command or timer. This option allows the car to be used to provide
express service for a subset of the building’s floors. Car behavior is determined by parame-
ters located on the Configuration > Car Operation > Shuttle service tab. Please refer to
“Car Operation - Shuttle Service” on page 9-88.
• Test: Indicates that the iBox Test switch is in the Test position and the elevator is in Test
mode, generally used to adjust or test the elevator. The elevator operates the same as in
normal passenger mode except that the doors are disabled and no hall calls are registered.
To Next Page
Loading...