iView - Controller View
9-86 Manual # 42-02-7223
• Disable car call button indicators: The car call buttons will not illuminate in response to
automatically generated Sabbath operation calls or call button activation.
• Disable position indicators: During Sabbath operation the position and direction indica-
tors shall be disabled (except for CE Electronics displays).
• Disable load weighing functions: During Sabbath operation the elevator's load weighing
functions shall be disabled (except for pre-torquing).
• Disable COP door buttons: During Sabbath operation all of the COP door buttons shall be
disabled.
• Sabbath operation recall flo0r: When Sabbath operation is activated, if a recall floor is des-
ignated, the car will first recall to this floor before beginning Sabbath operation service.
• Sabbath operation start floor: When Sabbath operation is activated, after traveling to the
recall floor (if designated), the car will travel to the start floor (if designated) before begin-
ning Sabbath operation service. The start floor options are:
• Bottom (unidirectional) = Start at the bottom floor and travel up, stopping at desig-
nated Sabbath floors until the top designated floor is reached. What happens next is
determined by the Sabbath trip interval timer and Sabbath operation return floor
parameters.
• Top (unidirectional) = start at the top floor and travel down, stopping at designated
Sabbath floors until the bottom designated floor is reached. What happens next is
determined by the Sabbath trip interval timer and Sabbath operation return floor
parameters.
• Current up (bidirectional) = start at the current floor and travel up (unless down pref-
erence exists, in which case travel down), stopping at designated Sabbath floors until
the top/bottom designated floor is reached. Then, if all designated floors have not been
served at least once, reverse direction, stopping at designated floors until the bottom/
top designated floor is reached. What happens next is determined by the Sabbath trip
interval timer and Sabbath operation return floor parameters.
• Current down (bidirectional) = start at the current floor and travel down (unless up
preference exists, in which case travel up), stopping at designated Sabbath floors until
the bottom/top designated floor is reached. Then, if all designated floors have not been
serviced at lease once, reverse direction, stopping at designated floors until the top/
bottom designated floor is reached. What happens next is determined by the Sabbath
trip interval timer and Sabbath operation return floor parameters.
• Sabbath operation return floor: The car shall travel to the return floor (if specified) after it
has finished servicing all of the Sabbath floors (at least once). Select None or any floor.
• Sabbath trip interval timer: Specifies the interval between Sabbath operation trips. During
the time between trips, the car operates in Passenger mode. A value of Non-stop = contin-
uous Sabbath operation.
• Sabbath door open timer: Specifies the amount of time the doors shall remain open at
each floor during Sabbath operation.
To Next Page
Loading...
Need help?
General