Configuration - Car Operation
9-87
9
iControl DC
Arrival lanterns During Sabbath operation the arrival lanterns shall operate as follows:
• Enable: Arrival lanterns are enabled.
• Disable: Arrival lanterns are disabled.
• Activate both up and down: (not used).
Status
• Sabbath service ON: LED lights green when Sabbath operation is On.
• Activate/Deactivate button: Software command used to turn Sabbath operation On or Off.
When Sabbath operation has been activated, the button caption changes to “Deactivate”.
Sabbath operation can also be activated/deactivated via a key switch-input, iMonitor com-
mand or a timer.
Sabbath Operation Floors Specifies the floors (front, rear or both openings) that are
to be serviced during Sabbath operation.
• To add or remove the check mark in an individual cell, click the cell.
• To add or remove check marks from a group of cells, click and drag to select the cells,
then click Select or Deselect.
• To add or remove check marks from a whole column, click the column label, then click
Select or Deselect.
To Next Page
Loading...