Controller - Setup Tabs
9-171
9
iControl DC
The Setup > Floor Heights > Learn tab contains:
Configuration data Learned and actual (previously saved) data detected by the Floor
Heights Learn procedure.
• Floors - the top floor configured on the Configuration > General > Floor data tab.
• Front markers - the number of front landing magnets detected.
• Landings - the number of floors where a front and/or rear landing magnet was detected
(includes false floors).
• Rear markers - the number of rear landing magnets detected.
• Openings - the number of floors with eligible openings (front and/or rear) per the Config-
uration > General > Floor data tab.
Edge data For diagnosing possible problems with floor magnets or magnet detection.
• Error - the error is displayed in feet and indicates the difference between the height
learned by the Floor Heights Learn procedure and the height currently detected by the Top
level up, Top level down, Bottom level up and Bottom level down sensors for the front
and/or rear landing magnets. A typical error reading is 0.02083 (1/4 inch) to 0.01041 (1/8
inch) or less. If the error is greater than 0.04166 (1/2 inch), it is recommended to re-do the
placement of the magnets and then re-learn the floor heights.
• Top level up - The ULM sensor has detected the top edge of a landing magnet. The ele-
vator is roughly aligned with the center of the landing magnets.
• Top level down - The DLM sensor has detected the top edge of a landing magnet. The
elevator is roughly six inches above the center of the landing magnet.
• Bottom level up - The ULM sensor has detected the bottom edge of a landing magnet.
The elevator is roughly six inches below the center of the landing magnet.
• Bottom level down - The DLM sensor has detected the bottom edge of a landing mag-
net. The elevator is roughly aligned with the center of the landing magnet.
• Count - the number of times each landing system leveling sensor has detected the top or
bottom of a front or rear landing magnet at the floor. These values will return to zero when
power is cycled or the controller is reset.
Learn metrics
• Floor - during the Floor Heights Learn operation, indicates the most recently learned
floor.
• Height - the learned height for the most recently learned floor.
• Last floor height - the incremental distance to the previously learned floor (difference
between the heights learned for the previous and most recently learned floors).
Leveling Sensor Indicates the current state (activated or deactivated) of the front and
rear Up leveling marker, Door zone and Down leveling marker sensors.
Outer level
• Velocity - the car speed at the time the last landing magnet edge was detected.
• Error - the difference between the learned and most recent car position when the last land-
ing magnet edge was detected.
To Next Page
Loading...