iView - System View
10-24 Manual # 42-02-7223
Per Floor Parking - User Defined Priority, Floor, and Door Times To select
priority, parking floor, and door times manually when the Parking method is set to “Per floor
parking”:
1. Select an entry row in the list and click Edit, or click Add if you are adding a new entry to
an unfilled table. (You may assign as many parking/floor sets as you have cars in the
group. If you want multiple cars to park at the same floor, set up multiple, identical
entries for that floor.)
2. Assign a priority of 1 through 4 to the floor if you want it recognized as the lobby floor
for this configuration.
Priorities 1 through 4 are treated as lobby parking floors (use lobby delay timers). Remaining
priorities are treated as non-lobby floors. Start and End floor selections are active only when
Sector parking has been chosen.
3. Select the parking floor.
4. Choose whether cars should park with front and/or rear doors closed, open, or open for
a number of seconds, then closed.
5. Click OK after making settings.
6. Continue selecting and setting additional priority/floor sets as needed.
To Next Page
Loading...
Need help?
General