System Configuration tab
10-25
10
iControl DC
Sector Parking - User Defined Priority, Floor, and Door Times To define
sectors, select priority, parking floor within the sector, and door times manually when Parking
method is set to “Sector parking”:
1. Select an entry row in the list and click Edit, or click Add if you are adding a new entry to
an unfilled table. (You may assign as many parking/floor sets as you have cars in the
group. If you want multiple cars to park at the same floor, set up multiple, identical
entries for that floor.)
2. Select a Priority. The higher the priority, the more iControl will attempt to maintain a
parked car in the sector. One (1) is the highest priority.
Priorities 1 through 4 are treated as lobby parking sectors (use lobby delay timers). Remaining
priorities are treated as non-lobby sectors.
3. Select the preferred parking floor within the sector.
4. Choose a starting floor (lowest), return floor and end floor (highest). This defines the
sector.
5. Choose whether cars should park with front and/or rear doors closed, open, or open for
a number of seconds, then closed.
6. Click OK after making settings.
7. Continue selecting and setting additional priority/floor sets as needed.
To Next Page
Loading...
Need help?
General