NETGEAR ProSAFE M7100-24X - Area Default-Cost (Ospf); Area Nssa (Ospf); Area Nssa Default-Info-Originate (Ospf)

Routing Commands
261
ProSafe Managed Switch
no 1583compatibility
This command disables OSPF 1583 compatibility.
Format no 1583compatibility
Mode
area default-cost (OSPF)
This command configures the default cost for the stub area. You must specify the area ID and
an integer value between 1-16777215.
Format area <areaid> default-cost <1-16777215>
Mode
area nssa (OSPF)
This command configures the specified areaid to function as an NSSA.
Format area <areaid> nssa
Mode
no area nssa
This command disables nssa from the specified area id.
Format no area <areaid> nssa
Mode
area nssa default-info-originate (OSPF)
This command configures the metric value and type for the default route advertised into the
NSSA. The optional metric parameter specifies the metric of the default route and is to be in
a range of 1-16777214. If no metric is specified, the default value is 10. The metric type can
be comparable (nssa-external 1) or non-comparable (nssa-external 2).
Format area <areaid> nssa default-info-originate [<metric>] [{comparable |
non-comparable}]
Mode
Router OSPF Config
Router OSPF Config
Router OSPF Config
Router OSPF Config
Router OSPF Config