NETGEAR ProSAFE M7100-24X - Lacp Partner System Priority; Lacp Partner System ID

Switching Commands
111
ProSafe Managed Switch
Note: This command is only applicable to physical interfaces.
no lacp partner port priority
Use this command to configure the default LACP partner port priority.
Format no lacp partner port priority
Mode
lacp partner system id
Use this command to configure the 6-octet MAC Address value representing the
administrative value of the Aggregation Port’s protocol Partner’s System ID. The valid range
of <system-id> is 00:00:00:00:00:00 - FF:FF:FF:FF:FF.
Default
Format lacp partner system id <system-id>
Mode
Note: This command is only applicable to physical interfaces.
no lacp partner system id
Use this command to configure the default value representing the administrative value of the
Aggregation Port’s protocol Partner’s System ID.
Format no lacp partner system id
Mode
lacp partner system priority
Use this command to configure the administrative value of the priority associated with the
Partner’s System ID. The valid range for <priority> is 0 to 65535.
Default
Format lacp partner system priority <priority>
Mode
Format lacp partner port priority <priority>
Mode
Interface Config
Interface Config
00:00:00:00:00:00
Interface Config
Interface Config
0x0
Interface Config