NETGEAR ProSAFE M7100-24X - Dos-Control Icmpfrag

Switching Commands
198
ProSafe Managed Switch
no dos-control icmpv4
This command disables Maximum ICMP Packet Size Denial of Service protections.
Format no dos-control icmpv4
Mode
dos-control icmpv6
This command enables Maximum ICMPv6 Packet Size Denial of Service protections. If the
mode is enabled, Denial of Service prevention is active for this type of attack. If ICMPv6 Echo
Request (PING) packets ingress having a size greater than the configured value, the packets
will be dropped if the mode is enabled.
Default
Format dos-control icmpv6 <0-16384>
Mode
no dos-control icmpv6
This command disables Maximum ICMP Packet Size Denial of Service protections.
Format no dos-control icmpv6
Mode
dos-control icmpfrag
This command enables ICMP Fragment Denial of Service protection. If the mode is enabled,
Denial of Service prevention is active for this type of attack. If packets ingress having
fragmented ICMP packets, the packets will be dropped if the mode is enabled.
Default
Format dos-control icmpfrag
Mode
no dos-control icmpfrag
This command disabled ICMP Fragment Denial of Service protection.
Format no dos-control icmpfrag
Mode
Format dos-control icmpv4 <0-16384>
Mode
Global Config
Global Config
disabled <512>
Global Config
Global Config
disabled
Global Config
Global Config