NETGEAR ProSAFE M7100-24X - Maximum-Paths (Ospf); Passive-Interface Default (Ospf)

Routing Commands
279
ProSafe Managed Switch
no redistribute
This command configures OSPF protocol to prohibit redistribution of routes from the
specified source protocol/routers.
Format no redistribute {rip | static | connected} [metric] [metric-type]
[tag] [subnets]
Mode
maximum-paths (OSPF)
This command sets the number of paths that OSPF can report for a given destination where
maxpaths is platform dependent.
Default
Format maximum-paths <maxpaths>
Mode
no maximum-paths
This command resets the number of paths that OSPF can report for a given destination back
to its default value.
Format no maximum-paths
Mode
passive-interface default (OSPF)
Use this command to enable global passive mode by default for all interfaces. It overrides
any interface level passive mode. OSPF will not form adjacencies over a passive interface.
Default
Format passive-interface default
Mode
no passive-interface default
Use this command to disable the global passive mode by default for all interfaces. Any
interface previously configured to be passive reverts to non-passive mode.
Format no passive-interface default
Mode
Router OSPF Config
4
Router OSPF Config
Router OSPF Config
disabled
Router OSPF Config
Router OSPF Config